GB/T 22079-2019
ActiveHV polymeric insulators for indoor and outdoor use—General definitions ,test methods and acceptance criteria
户内和户外用高压聚合物绝缘子 一般定义、试验方法和接收准则
Application Summary AI generated
This standard defines terms, test methods, and acceptance criteria for high-voltage polymeric insulators used in both indoor and outdoor electrical power systems. It applies to insulators in AC or DC systems with nominal voltages above 1000V, covering design verification, type tests, and routine tests to ensure reliability in transmission and distribution networks. The standard is critical for manufacturers, utilities, and testing laboratories to validate insulator performance under electrical, mechanical, and environmental stresses.
Related Standards
GB/T 19443-2004
Insulators for overhead lines with a nominal voltage above 1000V--Ceramic or glass insulator units for d.c. systems--Difinitions，test methods and acceptance criteria
GB/T 4585-2004
Artificial pollution tests on high-voltage insulators to be used on a.c. systems
GB/Z 23756.1-2009
Evaluation of electrical endurance of electrical insulation systems - Part 1: General considerations and evaluation procedures based on normal distributions
GB/Z 16935.2-2013
Insulation coordination for equipment within low-voltage systems―Part 2-1: Application guide-Explanation of the application of the IEC 60664 series, dimensioning example and dielectric testing
GB/Z 16935.6-2016
Insulation coordination for equipment within low-voltage systems—Part 2-2: Interface considerations—Application guide
GB/Z 37754-2019
Guidance on clearances and creepage distances in particular for distances equal to or less than 2mm—Test results of research on influencing parameters
GB/Z 43963-2024
Guidance for determination of clearances, creepage distances and requirements for solid insulation for equipment with a rated voltage above 1 000 V AC and 1 500 V DC, and up to 2 000 V AC and 3 000 V DC
GB/T 775.2-2003
Test method for insulators--Part2: Electrical test methods
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.